Site icon Canon Image Drivers || Canon Drivers and Support

Canon i-SENSYS MF4730 Driver Download

Canon i-SENSYS MF4730 Driver Download

Canon i-SENSYS MF4730 Driver Download

Canon i-SENSYS MF4730 Driver Download Support for:


Canon i-Sensys MF4730 made me scratch my head for a while. It is a small, all-in-one laser machine that can be connected via USB or network. The reason my head itches is because it only works on 32 bit systems.

The printer is like a 36x36x34 cm cube, and since the final figure is the height, you will need at least a few extra centimeters to fit anything on the tablet, then it is even closer to the cube. Just under 12 pounds.

The software refuses to install on 64 bit systems and they refused to install for me, although I looked at the Canon site and there were several drivers there claiming to be for 64 bit Windows, so I installed it on a 32-bit system and installed it without any problem.

All controls are on the front panel and the power switch is in the lower-left corner of the main paper input tray. On the elevator rack to the left of the 6×3.5cm five-line display, there are five buttons, to the right of which are the ubiquitous five-way joystick and two more buttons. This is followed by 12 buttons for device fax functions (if installed) and eight more, including buttons that can be programmed for specific functions.

On the rear left is the power port and USB input. I am assuming the fax and network devices are in the above series units.

I got 22 hours per minute without any problem, but you must be present during printing as the pages are falling off the shelf they were delivered from and if nothing else, the order will be out of order, but they may cause more problems than that …

Of course, copying doesn’t require the computer to be turned on or plugged in, and it has many options on its five-line display. One sheet placed on the flatbed is copied within 8 seconds from standby mode.

The scan should work both ways, but as with another recently reviewed product, I only managed to get it to work when I asked for it from the computer, and then after I made all the selections, the first page was captured and delivered as an image within 8 seconds. Of course, you can OCR the output to make the text editable.

Almost any A4 page can be printed, but you must leave 5mm margins on each side.

The paper input tray holds 250 sheets. I think it might be tight, but I see 200 is a reasonable number because regular readers will always know that I am using a combination of weight and type to see how well it fits between the middle. print and I can report no paper jam

Do not place letterhead or envelopes on the main paper tray. It has a manual feed slot, ideal for

I note from the PDF file that the paper output rack should hold 100 pages; I don’t see this being possible unless I was given a piece of paper to hold the paper in place.

In my tests, I found that the time from power on to print/scan / ready to copy was 13.5 seconds.

For a no-frills printer that is fairly reliable and has a good copy function that can scan from a flatbed or sheet-fed, it’s worth taking a look at, but remember that it requires – as far as I can tell – 32-bit Windows.

The Canon i-Sensys MF4730 is available from the link below for £ 140.38 with free shipping.


Canon i-SENSYS MF4730 Drivers for Windows 32bit

Canon i-SENSYS MF4730 Drivers for Windows 64bit

Canon i-SENSYS MF4730 Software for Mac

Canon i-SENSYS MF4730 Drivers for Linux 32bit/ 64bit

Canon i-SENSYS MF4730 Software Download

Canon i-SENSYS MF4730 Manuals Download

Exit mobile version